Snapper EMLP21501KWV Manual Do Utilizador

 

 
3.1 INTRODUCTION 

To retain the quality of the mower, use genuine 
SNAPPER replacement parts only. Contact a local 
SNAPPER dealer for parts and service assistance.  
For the correct part or information for a particular 
mower, always mention model and serial number. 

1.  Disconnect spark plug wire and secure end away 
from plug. The items needed to perform oil change 
are: cloth rags, (1) 3/8” drive ratchet with a short 
extension and (1) shallow pan. 
2.  Tilt mower up on its rear wheels for access to the 
oil drain plug located underneath the mower deck. 
Do not tilt mower with spark plug or carburetor 
down. See Figure 3.1. 

 
 

 

 
 

 

3.  Place shallow pan underneath the approximate 
center of the oil drain plug. 
4.  Loosen with ratchet and short extension, but do 
not remove oil drain plug. Loosen plug until you can 
turn it with your fingers. 
 
 

5. Lower the mower down and place the piece of 
wood under left rear wheel. Reach back under 
mower and remove drain plug and allow oil to drain 
out completely in pan. Some oil may spill onto drive 
belt and hands, immediately wipe hands clean with 
cloth rags. Dispose of oil properly. 
 

NOTE: Some oil may drain onto drive belt but will not 
affect the operation or life of the belt. Wipe excess oil 
from belt. 

 
6. Tilt mower back up and replace drain plug. 
Tighten securely but do not over tighten. 
7.  Fill engine with oil as specified in Engine Owner’s 
Manual. Thereafter, change oil after each 25 hours 
of use. 

 

3.2.2.  GREASE LEVEL IN TRANSMISSION 
The transmission requires no lubrication or 
maintenance. If transmission leaks or malfunctions, 
return machine to an authorized Snapper dealer for 
repair. 
 
3.2.3.  WHEEL DRIVE CONTROL 
The wheel drive control requires periodic adjustment 
to maintain proper drive function. The adjustment is 
performed with the turnbuckle located on the wheel 
drive control cable and requires no tools. Refer to 
Section “WHEEL DRIVE CONTROL 
ADJUSTMENT”.