Adtran 3458-poe Manual Do Equipamento
Unit Installation
NetVanta 3000 Series Hardware Installation Guide
78
Copyright © 2010 ADTRAN, Inc.
61200860L1-34AA
Figure 40. Wall Mounting the NetVanta 3120/3130/3200
Instructions for Wall Mounting NetVanta 3120/NetVanta 3130/NetVanta 3200
Step
Action
1
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so
that the LEDs are viewable.
that the LEDs are viewable.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide sufficient long-
term stability.
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide sufficient long-
term stability.
3
Install two #8 PAN head screws (1-inch or greater in length) into the mounted board, following these
guidelines and referring to
guidelines and referring to
.
•
Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning by using
the location of the two keyed insets on the bottom of the unit as a guide.
the location of the two keyed insets on the bottom of the unit as a guide.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4-inch of the screws protruding from the board to allow the heads of the screws
to slide into place in the unit’s keyed insets.
to slide into place in the unit’s keyed insets.
4
Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.
5
.