ZyXEL NBG-318S Guia Do Utilizador

 Chapter 23 Troubleshooting

NBG-318S User’s Guide

If you reset the NBG-318S, you lose all of the changes you have made. The NBG-318S re-
loads its default settings, and the password resets to 1234. You have to make all of your 
changes again.

V

You will lose all of your changes when you push the RESET button.

To reset the NBG-318S,

1 Make sure the PWR LED is on and not blinking. 
2

P

ress and hold the RESET button for five to ten seconds. Release the RESET button 

when the PWR LED begins to blink. The default settings have been restored.

If the NBG-318S restarts automatically, wait for the NBG-318S to finish restarting, and log in 
to the web configurator. The password is “1234”.
If the NBG-318S does not restart automatically, 

di

sconnect and reconnect the NBG-318S’s 

power. Then, follow the directions above again.

V

I cannot access the NBG-318S or ping any computer from the WLAN (wireless 
AP or router).

1 Make sure the wireless LAN is enabled on the NBG-318S
2 Make sure the wireless adapter on the wireless station is working properly.
3 Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible 

and supports the same wireless standard as the NBG-318S.

4 Make sure your computer (with a wireless adapter installed) is within the transmission 

range of the NBG-318S.

5 Check that both the NBG-318S and your wireless station are using the same wireless and 

wireless security settings.

6 Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the 

NBG-318S. 

7 Make sure you allow the NBG-318S to be remotely accessed through the WLAN 

interface. Check your remote management settings.

• See the chapter on Wireless LAN in the User’s Guide for more information.