ZyXEL P-663H-51 Guia Do Utilizador
Chapter 9 Quality of Service (QoS)
P-663H-51 User’s Guide
92
9.3 Queue Configuration
Click Advanced > Quality of Service > Queue Configuration to open the following screen.
This screen lists the QoS queues. A QoS queue sets the priority used for incoming packets that
the QoS classifier has grouped into a flow.
This screen lists the QoS queues. A QoS queue sets the priority used for incoming packets that
the QoS classifier has grouped into a flow.
Figure 49 Advanced > Quality of Service > Queue Configuration
The following table describes the labels in this screen.
9.4 Adding a Queue
Click Advanced > Quality of Service > Queue Configuration > Add to open the following
screen. Use this screen to configure a QoS queue. A QoS queue sets the priority used for
incoming packets that the QoS classifier has grouped into a flow.
screen. Use this screen to configure a QoS queue. A QoS queue sets the priority used for
incoming packets that the QoS classifier has grouped into a flow.
"
You can only add QoS queues for WAN interfaces that have QoS enabled.
Table 35 Advanced > Quality of Service > Queue Configuration
LABEL
DESCRIPTION
Interface name
This field displays the WAN connection’s DSL port, Virtual Path Identifier, and
Virtual Channel Identifier.
Virtual Channel Identifier.
Description
This field displays any extra configured identification information.
Precedence
This shows the queue’s priority relative to the other queues. The lower the
number, the higher the priority. 1 is the highest priority. 4 is the lowest.
number, the higher the priority. 1 is the highest priority. 4 is the lowest.
Queue Key
This is the queue entry’s index number.
Enable
Select the check box to enable this classifier.
Remove
To remove an entry, select its Remove check box and click the Remove button.
Add
Click this button to go to a screen where you can configure settings for a new
QoS queue.
QoS queue.
Remove
To remove an entry select its Remove check box and click the Remove button.
Save/Reboot
Click this button to apply and save your changes. The ZyXEL Device restarts.