ZyXEL P-663H-51 Guia Do Utilizador
Chapter 9 Quality of Service (QoS)
P-663H-51 User’s Guide
93
Figure 50 Advanced > Quality of Service > Queue Configuration > Add
The following table describes the labels in this screen.
9.5 Class Setup
Click Advanced > Quality of Service > QoS Classification to open the following screen.
This screen lists the QoS classifiers. A classifier groups upstream traffic into data flows
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow. The
classifier also assigns a specific QoS queue, DSCP mark, and/or IEEE 802.1p tag.
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow. The
classifier also assigns a specific QoS queue, DSCP mark, and/or IEEE 802.1p tag.
Table 36 Advanced > Quality of Service > Queue Configuration > Add
LABEL
DESCRIPTION
Queue
Configuration Status
Configuration Status
Select Enable to turn on this queue.
Queue
Select the WAN connection’s DSL port, Virtual Path Identifier, and Virtual
Channel Identifier.
Channel Identifier.
Description
This field displays any extra configured identification information.
Queue Precedence
Set the queue’s priority relative to the other queues. The lower the number, the
higher the priority. 1 is the highest priority. 4 is the lowest.
higher the priority. 1 is the highest priority. 4 is the lowest.
Save/Apply
Click this button to save the changes and have the ZyXEL Device start using
them.
them.