ZyXEL P-663H-51 Guia Do Utilizador

Chapter 9 Quality of Service (QoS)

P-663H-51 User’s Guide

Rule Status

Select whether or not the classifier is to be active.

Assign 
Classification 
Queue

Select the QoS queue the ZyXEL Device uses for the packets of upstream traffic 
that match this QoS classifier.

Assign 
Differentiated 
Services Code 
Point (DSCP) Mark

Select the DSCP mark the ZyXEL Device assigns to the packets of upstream 
traffic that match this QoS classifier.

Mark 802.1p if 
802.1q is enabled

Select the IEEE 802.1p mark the ZyXEL Device assigns to the packets of 
upstream traffic that match this QoS classifier. This only applies when IEEE 
802.1q is enabled. You enable IEEE 802.1q by enabling VLAN multiplexing in 
the WAN screens (see 

Physical LAN Port

Select the source Ethernet port of the traffic.

Protocol

Select the type of packets.

Differentiated 
Services Code 
Point (DSCP) 
Check

Select the DSCP mark to check upstream traffic for.

IP Address/ 
Vendor Class ID 
(DHCP Option 60)/ 
User class ID 
(DHCP option 77)    

Select whether to check for a source IP address, vendor class ID, or user class 
ID. Then specify the source IP address, vendor class ID, or user class ID.

Source Subnet 
Mask 

Specify the subnet mask of the device that sent the traffic.

UDP/TCP Source 
Port (port or 
port:port)

This is the port number that a device used to send the traffic.

Destination IP 
Address

Specify the IP address of the device that the traffic is going to.

Destination Subnet 
Mask

Specify the subnet mask of the device that the traffic is going to.

UDP/TCP 
Destination Port 
(port or port:port)

Specify the port number on a device to which the traffic is going.

Source MAC 
Address

Specify the MAC address of the device that sent the traffic.

Source MAC Mask

Specify the MAC address subnet mask of the device that sent the traffic.

Destination MAC 
Address

Specify the MAC address of the device that the traffic is going to.

Destination MAC 
Mask

Specify the MAC address subnet mask of the device that the traffic is going to.

802.1p Priority

Specify the IEEE 802.1p mark on the traffic.

Save/Apply

Click this button to save the changes and have the ZyXEL Device start using 
them.

Table 38   QoS Class Configuration (continued)