Bizfon 680 Guia Do Utilizador
Appendix A Professional Installation Guide
78
Bizfon , Inc.
1. Press the blue button on Unit 1. You hear:
“Welcome to the Bizfon diagnostics. Note that
during the diagnostics, the Bizfon may not be
used for calls. To run diagnostics on incoming
telephone lines and telephones, press the button
again.”
during the diagnostics, the Bizfon may not be
used for calls. To run diagnostics on incoming
telephone lines and telephones, press the button
again.”
2. Push the button again. You hear:
“Now running the incoming telephone lines test.
The LEDs for each incoming line flash if a dial
tone is detected. Each line is retested every few
seconds. To end this test and continue with the
voice quality test, press the button again.”
The LEDs for each incoming line flash if a dial
tone is detected. Each line is retested every few
seconds. To end this test and continue with the
voice quality test, press the button again.”
While the diagnostics run, verify that all incoming lines have
blinking LEDs. This indicates that they are functioning cor-
rectly.
blinking LEDs. This indicates that they are functioning cor-
rectly.
3. Push the button again. You hear:
“Incoming telephone lines test complete. Now
running the voice quality test. Please wait for the
test to complete.”
running the voice quality test. Please wait for the
test to complete.”
The voice quality test determines the sound quality of your
phone lines and automatically selects parameters to optimize
the audio for your installation. The test normally takes about
two minutes to complete. You hear a prompt letting you know
that the test is in progress as the test is running.
phone lines and automatically selects parameters to optimize
the audio for your installation. The test normally takes about
two minutes to complete. You hear a prompt letting you know
that the test is in progress as the test is running.
When the test completes, you hear:
“Voice quality test complete. Now running the
extensions test. Extensions will ring consecutively
until the button is pushed again.”
extensions test. Extensions will ring consecutively
until the button is pushed again.”
This test verifies that all physical extensions are connected to
the Bizfon correctly.
the Bizfon correctly.
4. Push the button again. You hear: