Bizfon biztouch 3 Guia De Referência
Slide the control to select speaker or headset
output when using HANDSFREE.
output when using HANDSFREE.
To change the selection during a call,
you must be using the HANDset.
you must be using the HANDset.
Up to five people can join a conference call in the Meeting Room.
Press CONF.
1.
Dial 290.
2.
Follow the prompts.
To start a conference call in the Meeting Room with your
current caller and other callers on hold:
current caller and other callers on hold:
To start a conference when you have no active calls:
Selecting Output for Handsfree Operation
For a list of recommended headsets,
visit www.bizfon.com or call 299.
Initiating Conference Calls
Hands-free announce allows you to answer calls from internal
extensions without picking up the handset. If someone calls you from
another extension when you have hands-free announce enabled, your
telephone rings once and then goes into hands-free mode. The
telephone plays a beep and you can start talking with the caller.
extensions without picking up the handset. If someone calls you from
another extension when you have hands-free announce enabled, your
telephone rings once and then goes into hands-free mode. The
telephone plays a beep and you can start talking with the caller.
To enable or disable hands-free announce:
1. Press SETUP, select SETTINGS and press ENTER to enter
Personal Settings
.
2. Enter
and your password.
3. Press
for Additional Settings.
4. Press
to enable or disable hands-free announce.
(refer to ** on front)
#
9
3
3
Using Hands-Free Announce
Troubleshooting Speakerphone Operation
Problem:
Cause and Solution:
Cause and Solution:
Problem:
Cause and Solution:
Cause and Solution:
Problem:
Cause and Solution:
Cause and Solution:
Problem:
Cause and Solution:
Cause and Solution:
You cannot hear sound from the speaker.
If you are using the speakerphone in a noisy
environment, the microphone might pick up these sounds and prevent
the speakerphone from receiving sound. Use your speakerphone in a
quiet area.
the speakerphone from receiving sound. Use your speakerphone in a
quiet area.
Callers tell you that your audio does not sound clear.
Recessed office areas, such as next to cabinets,
can cause audio distortion. Locate your phone away from these areas.
You cannot hear sound from the speaker.
The handsfree switch might be set to headset. If
you want sound to come from the speaker, set the switch to
.
Speakerphone does not stay on when you press HANDSFREE.
The BizTouch 3 requires an AC adapter for the
speakerphone. Be sure that the AC adapter is connected properly.
Making a hands-free call:
Receiving a call:
Switching between Speaker or Headset and Handset:
!
Press HANDSFREE and wait for dial tone.
Adjust volume if needed by using
.
Press HANDSFREE again to hang up the phone.
If you are using a headset, pressing HANDSFREE activates the
headset.
headset.
Press HANDSFREE instead of picking up the handset when the
phone rings.
phone rings.
Adjust volume if needed by using
.
Press HANDSFREE again to hang up the phone.
You can switch between the speaker or headset and the handset while
the phone is dialing a number, or anytime during a conversation.
the phone is dialing a number, or anytime during a conversation.
Speaker or headset to handset: Pick up the handset.
Handset to speaker or headset: Press HANDSFREE then hang up
the handset.
the handset.
Be sure to press HANDSFREE before hanging up the
handset or you will disconnect the call.
!
!
!
!
!
!
!
!
!
!
!
!
NOTE:
Using the Speakerphone