Ricoh 2232c Guia Do Utilizador

Appendix

106

*1

IP address

Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.

❒ The default value of TTL is “1”. A

search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.

❒ The acceptable TTL value is 1 - 255.

Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.

❒ You can use this function when the

optional IEEE 1394 interface board
is installed.

❖

❖

❖

❖ Viewing settings

The following command displays
the current IEEE 1394 (SCSI print)
settings:

❖

❖

❖

❖ Bidirectional configuration for IEEE

Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is “on”.

Use the "wiconfig" command to con-
figure IEEE 802.11b settings.

❒ You can make settings when in-

stalling the optional IEEE 802.11b
interface unit.

❖

❖

❖

❖ View settings

The following command displays
the current IEEE 802.11b settings.

msh> wiconfig
The following command displays
the IEEE 802.11b card information.

❒ If the IEEE 802.11b interface is

not working correctly, the op-
tional IEEE 802.11b interface unit
information is not displayed.

route get 
{destina-
tion 

Displays only route informa-
tion corresponding to a spec-
ified destination. When the 
destination is unspecified, all 
routing information is dis-
played.

route active 
{host | net} 
destination 
on/off

You can turn the specified 
destination on or off. Host be-
comes the default.

route add 
default 
gateway 

You can set the default gate-
way address.

route flush

Deletes all routing informa-
tion.