Ricoh 2232c Guia Do Utilizador

Appendix

108

❒ When changing the interface to

IEEE 802.11b, see p.98 “TCP/IP
address”.

❒ When configuring the IEEE

802.11b TCP/IP, see p.98 “TCP/IP
address”.

Use the "spoolsw" command to con-
figure Job Spool settings.

❒ You can only specify LPR, IPP, and

SMB protocol.

❒ This information cannot reload au-

tomatically when you confirm Job
S p o o l   s e t t i n g s   w i t h  t h e   W e b
browser. Click [Reload] or [Refresh]
on the Web browser when you
want to reload this information.

❖

❖

❖

❖ Reference

The Job Spool setting appears.

❖

❖

❖

❖ Job Spool setting

❒ Select [on] to enable Job Spool or

 to disable it.

❖

❖

❖

❖ Protocol configuration

To change protocol settings, use
the following command. You can
specify the setting for "lpr", "ipp"
or "smb".
• lpr

• ipp

• smb

Use the "hostname" command to
change the printer name.

*1

If you did not enter the interface

name, it will be automatically set to

the Ethernet interface.

*2

Available when the optional IEEE

802.11b interface unit is installed.

*3

Available when the optional IEEE

1394 interface board is installed.

rate [auto|11m 
|5.5m|2m|1m]

You can set the 
IEEE 802.11b trans-
mission speed.
The transmission 
speed you specify 
here is the speed at 
which data is sent. 
You can receive 
data at any speed.
auto: automatical-
ly set (default)

11m: 11 Mbps 
fixed

5.5m: 5.5 Mbps 
fixed

2m: 2 Mbps fixed
1m: 1 Mbps fixed

ether

Ethernet interface 

wlan  

IEEE 802.11b interface

ip1394 

IEEE 1394 interface