Nortel 4134 Instrução De Instalação
Installing the interface modules
47
Slots 1–4 are Small Module slots. Slots 5–7 are Medium Module slots. If
you insert a Large Module, it spans slots 6 and 7. In this case, the Large
Module is identified in the Command Line Interface (CLI) as slot 6.
you insert a Large Module, it spans slots 6 and 7. In this case, the Large
Module is identified in the Command Line Interface (CLI) as slot 6.
Average time to install an interface module: 1 minute.
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an ESD jack when working with
interface modules.
antistatic wrist strap connected to an ESD jack when working with
interface modules.
CAUTION
Risk of equipment damage
Always handle interface modules by the edges, or by using the
levers, where applicable.
levers, where applicable.
Prerequisites
•
Ensure you have a Phillips #2 screwdriver.
Installing a Small Module
Procedure steps
Step
Action
1
Using a Phillips screwdriver #2, remove the slot cover plate from the
slot in which you are installing the module.
slot in which you are installing the module.
2
Align the module with the slot and the slot module guides.
3
Slide the module into the chassis until its connector panel touches
the chassis back panel.
the chassis back panel.
4
Push gently, but firmly, to seat the connector on the interface module
in the chassis back panel.
in the chassis back panel.
5
Using a Phillips screwdriver, tighten the two captive screws to secure
the module to the chassis.
the module to the chassis.
—End—
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301
01.02
Standard
10.0
7 August 2007
Copyright © 2007, Nortel Networks
.