Nortel 4134 Instrução De Instalação
Hot swapping interface modules
49
4
Align the Large Module with the slot and the slot module guides
on the outside edges of the slot.
on the outside edges of the slot.
5
Slide the module into the chassis until its connector panel touches
the chassis back panel.
the chassis back panel.
6
Push gently, but firmly, to seat the connector on the interface module
in the chassis back panel.
in the chassis back panel.
7
Ensure the levers on the module are flush with the front panel of
the Secure Router 4134.
the Secure Router 4134.
8
Using a Phillips screwdriver, tighten the two captive screws to secure
the module to the chassis.
the module to the chassis.
—End—
Hot swapping interface modules
If an interface module fails and you must replace it, you can hot swap the
module. All of the Secure Router 4134 external interface modules are hot
swappable.
module. All of the Secure Router 4134 external interface modules are hot
swappable.
ATTENTION
Hot swap an interface module only if the Secure Router 4134 recognizes the card.
When a card fails to initialize, the Secure Router 4134 should still recognize that
the module is installed. Use the
When a card fails to initialize, the Secure Router 4134 should still recognize that
the module is installed. Use the
show chassis
command to verify that the
Secure Router 4134 recognizes that the interface module is installed.
Nortel Secure Router 4134
Installation — Hardware Components
NN47263-301
01.02
Standard
10.0
7 August 2007
Copyright © 2007, Nortel Networks
.