ONKYO DX-C390 Manual De Instruções

Página de 28
 
11
 
Before Using the DX-C390
 
Notes:
 
• The batteries should last for about six months, 
although this will vary with usage.
• If the remote controller doesn’t work reliably, try 
replacing the batteries.
• Don’t mix new and old batteries or different types of 
batteries.
• If you intend not to use the remote controller for a long 
time, remove the batteries to prevent damage from 
leakage or corrosion.
• Flat batteries should be removed as soon as possible to 
prevent damage from leakage or corrosion.
To use the remote controller, point it at the DX-C390’s 
remote control sensor, as shown.
 
Notes:
 
• The remote controller may not work reliably if the 
DX-C390 is subjected to bright light, such as direct 
sunlight or inverter-type fluorescent lights. Keep this 
in mind when installing the DX-C390.
• If another remote controller of the same type is used in 
the same room, or the DX-C390 is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the 
DX-C390 is installed in a rack behind colored glass 
doors. Keep this in mind when installing the 
DX-C390.
• The remote controller will not work if there’s an obsta-
cle between it and the DX-C390’s remote control sen-
sor.
 
Installing the Remote Controller’s 
Batteries
 
1
 
Remove the battery compartment cover, 
as shown.
 
2
 
Insert the two supplied batteries (AA/R6) 
in accordance with the polarity diagram 
inside the battery compartment. 
 
3
 
Replace the battery compartment cover.
 
Using the Remote Controller
30
°
30
°
DX-C390
Appro
x.
 16 ft.
 (5 m)
Remote control sensor
DX-C390_En.book Page 11 Wednesday, August 27, 2003 5:49 PM