ONKYO TX-NR801 Manual De Instruções

22

Connecting to Audio/Video Equipment—Continued

If you are connecting a digital output device to the 
VIDEO 1 jack instead of a VCR, connect it to either the 
DIGITAL IN COAX jack or DIGITAL IN OPT jack, 
depending on the type of connector on the device.
On the initial settings of the TX-NR801/TX-NR801E, 
the VIDEO 1 input source is set for digital input at 
the COAX 2 jack.
If the digital connection is made at a different jack, this 
must be changed at Setup Menu 

→ Input Setup → 

Digital Setup (See page 36).

Using RCA video connection cables, connect the video 
output jack (composite) of the device to the VIDEO 2 
VIDEO IN jack of the TX-NR801/TX-NR801E and 
connect the video input jack of the device to the VIDEO 
2 VIDEO OUT jack of the TX-NR801/TX-NR801E. Or 
if the device has S video input and output jacks, connect 
them to the VIDEO 2 S VIDEO IN and OUT jacks of the 
TX-NR801/TX-NR801E using S video connection 
cables. Or if the device has component video outputs, 
connect them to one of the banks of COMPONENT 
VIDEO INPUT jacks on the TX-NR801/TX-NR801E.
On the initial settings of the TX-NR801/TX-NR801E, 
the VIDEO 2 input source is set for the 
COMPONENT VIDEO INPUT 2 jacks.
If you connect the device to the COMPONENT VIDEO 
INPUT 1 jacks, this must be changed at Setup Menu 

→ 

Input Setup 

→ Video Setup → Component Video (See 

page 38).
Using RCA audio connection cables, connect the audio 
output jacks of the device to the VIDEO 2 AUDIO IN 
jacks of the TX-NR801/TX-NR801E and connect the 
audio input jacks of the device to the VIDEO 2 AUDIO 
OUT jacks of the TX-NR801/TX-NR801E. Make sure 
that you properly connect the left channels to the L 
jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the 
DIGITAL IN COAX jack or DIGITAL IN OPT jack of 
the TX-NR801/TX-NR801E, depending on the type of 
connector on the device.
On the initial settings of the TX-NR801/TX-NR801E, 
the VIDEO 2 input source is set for digital input at 
the COAX 3 jack.
If the digital connection is made at a different jack, this 
must be changed at Setup Menu 

→ Input Setup → 

Digital Setup (See page 36).
If the device has a digital input, connect it to the DIGI-
TAL OUT OPT jack of the TX-NR801/TX-NR801E for 
digital recording of the REC OUT signal from the 
TX-NR801/TX-NR801E.
However, if the same device also has a digital output 
and it has already been connected to the TX-NR801/
TX-NR801E, you cannot connect the digital input of 
the device to the DIGITAL OUT jack of the TX-
NR801/TX-NR801E simultaneously.
Note:
The output from the DIGITAL OUT jack of the 
TX-NR801/TX-NR801E is only the digital signal input 
to the DIGITAL IN jack.