ONKYO TX-NR801 Manual De Instruções

86

When programming the commands of another remote 
controller to the RC-511M remote controller, you must 
first decide under to which MODE button you want the 
commands to be linked. In general, you will select the 
MODE button that corresponds to the component you are 
programming. For example, if you are programming the 
functions from a remote controller for a compact disc 
player, you would choose the CD MODE button. Then, 
by pressing the CD MODE button, the buttons on the RC-
511M remote controller will change to the commands 
you program here to operate the compact disc player.
After programming which MODE button to use, you 
will then transfer the separate commands from the other 
remote controller over to the RC-511M remote control-
ler one at a time. Each command is then programmed to 
a different button on the RC-511M remote controller. 
Any button is programmable for this step except for the 
eight MODE buttons (RCVR, CD, DVD, SAT/MD, 
NET A, TV, VCR, and CABLE), the two MACRO but-
tons (1 and 2), and the LIGHT button. 
Even after the commands have been memorized, keep 
your old remote controller in a safe place. If for some rea-
son the commands are lost (e.g., when the batteries run 
down), it will be necessary to memorize them once again.

P

O

W

E

R

S

LE

E

P

D

IM

M

E

R

S

U

R

M

O

D

E

V

ID

E

O

-1

V

ID

E

O

-2

TA

P

E

D

V

D

C

 D

C

 D

D

V

D

TU

N

E

R

TU

N

E

R

P

H

O

N

O

IN

P

U

T S

E

LE

C

TO

R

D

IS

C

O

LU

M

E

C

H

 S

E

L

P

R

E

S

E

T

TE

S

T

TO

N

E

M

U

LT

I-C

H

IN

PU

T

G

R

O

U

P

While pressing and holding down the 
desired MODE button on the remote con-
troller, press the ENTER/ZONE 2 button 
and then release both buttons.
The SEND/LEARN indicator lights when the 
MODE button is pressed and turns off when the 
ENTER button is pressed. When the indicator 
turns off, release both buttons. The SEND/
LEARN indicator lights again.

Press and release the button on the 
remote controller to which you want to 
transfer the next command.
You may select any button excluding the eleven 
ones indicated in the figure below. When you 
press the button, the SEND/LEARN indicator 
turns off. When you release the button, the indica-
tor lights again.
If you press the wrong button by mistake, press 
that same button again. The SEND/LEARN indi-
cator flashes twice, and the remote controller 
exits the programming mode.

Press and hold down the button (that cor-
responds to the command you are pro-
gramming) on the remote controller of the 
other device until the SEND/LEARN lamp 
on the remote controller flashes twice.
After flashing twice, the SEND/LEARN indica-
tor will light again.

Repeat Steps 3 and 4 to transfer all the 
commands you desire from the other 
remote controller and program them to 
buttons on the remote controller under 
the same MODE.
Repeat Steps 2 through 4 to program commands 
to a different MODE (e.g., when programming 
from a different remote controller).