ONKYO TX-NR801 Manual De Instruções

88

A macro function enables you to program a series of 
button operations (up to 16) on the remote controller 
into a single button. The series of operations are then 
called a macro. For example, to play a compact disc 
player connected to the TX-NR801/TX-NR801E nor-
mally, you must perform the following steps:

By using the macro function, you can perform the above 
five operations by only pressing one button.

Tips:
• If you erase or change the command of a button pro-

grammed in the macro, that operation of that button 
will no longer work in the macro. In this case, it will 
be necessary for you to reprogram the macro in order 
to avoid incorrect operation.

• The codes programmed into the macro will be trans-

mitted at an interval of 0.5 seconds. However, some 
devices may not be able to complete one operation in 
0.5 seconds and may miss the next code. In this case, 
after pressing one operation button, you can press the 
same MODE button again before pressing the next 
operation button to add another 0.5 seconds between 
the two operations.

With the macro function, you can program a series of 
button operations as a macro into the MACRO button so 
the macro can be executed with just one touch. Note 
that for the macro function, only two macros can be 
programmed. For example, to program the macro 
described above on this page for the MACRO button, 
perform the steps given below.

Notes:
• You may program up to 16 button operations into the 

macro function. If you try to program a 17th opera-
tion, it will be ignored, and programming is stopped.

• If the SEND/LEARN indicator quickly flashes three 

times and turns off, then the remote controller has 
exited the programming mode because either you 
have made a mistake during programming or a time-
out has occurred because no button was pressed. 
Resume from Step 1.

Press and hold down any one of the 8 
MODE buttons, press the MACRO 1 (or 2) 
button, and then release both buttons.
When you press the MODE button, it lights and 
the SEND/LEARN indicator lights. When you 
press the MACRO 1 (or 2) button, the indicator 
turns off. When you release the buttons, the indi-
cator flashes briefly and then lights again.

→ ON → CD (INPUT SELEC-

→ CD MODE → playback ( ) but-

ton).
When you press each button, the SEND/LEARN 
indicator turns off. When you release the button, 
the indicator lights.

Press the MACRO 1 (or 2) button to com-
plete the procedure.
The SEND/LEARN indicator slowly flashes 
twice.