Elmo EDR-X1 Manual Suplementar

3.  Specify the start position and end position. 
4.  Click START 

 

 

 

4-2 Pic by Pic (FWD) 

 

 

 

Display the next picture after the playback position. 

Note:  If no image data  is recorded before the playback position, 
this function cannot be performed. 

 

4-3 Pic by Pic (RVS) 

 

 

 

Display the previous picture before the playback position 

Note:  If no image data is recorded before the playback position, 
this function cannot be performed. 

 

4-4 Accurate Search 

 

 

 

Display a picture at the time of playback position + skipped time. 

Note 1: If no picture exists at the time requested, the next 
closest picture to the requested time will be displayed. 
Note 2: If you set Time Skip (FWD) function at the end of 
recorded date and search, screen shows an error. 
Note 3: If you set Time Skip (RVS) function at the beginning of 
recorded date and search, screen shows an error. 
Note 4: In the case that the playback position is 16:30:30 on 
ARP/01/04 and the previously recorded data was at 16:20:30 on 
APR/01/04, and if you set Time Skip (RVS) function with 1 SEC 
and search, screen shows an error because of the reason of 
above Note 1. 
 

MENU 

 

5-1 Go to Network Connection 

Disconnect the current connection and connect it again at the 
NETWORK CONNECTION screen. 

5-2 EDR mode refresh 

POWER-ON MODE, REWRITE MODE PLAYBACK MODE 

5-3 Screen selection 

Select Normal screen or Multi screen 

5-4 Information 

IP Address of the EDR 

 

 

 

Current Program Version 

 
 
 

 
Message  

Cause   

 

Power of EDR is off or LAN cable is disconnected. 

If it can be connected to by pinging, go to NETWORK CONNECT screen 
and reconnect. 

 
Measure 

1. Transmission error to DVR 
2. EDR is not in normal condition (Power LED on), or recorded data was    
deleted by disc formatting, during connection. 

Check the EDR and reconnect