Elmo EDR-X1 Manual Suplementar
Message
Capture disabled or no space on hard disk
Cause
1. Transmission error to DVR
2. No space on hard disk to record data
3. EDR is not in normal condition (Power LED on), or recorded data was
deleted by disc formatting, during connection.
2. No space on hard disk to record data
3. EDR is not in normal condition (Power LED on), or recorded data was
deleted by disc formatting, during connection.
Measure
Check the remaining space on the hard disk, EDR and reconnect.
Message
Accurate Search Error
Cause
Accurate search is disabled
Measure
In case of FWD direction, Accurate Search was set at or beyond the end
of recorded data. In case of RSV direction, 1) Accurate Search was set
at or beyond the beginning of recorded data, or 2) no data at the time
requested and the same playback position was searched.
of recorded data. In case of RSV direction, 1) Accurate Search was set
at or beyond the beginning of recorded data, or 2) no data at the time
requested and the same playback position was searched.
Message
Command Error
Cause
Command signal sent from EDR was not recognized. EDR is not normal
condition (Power LED on), or no recorded data.
condition (Power LED on), or no recorded data.
Measure
Check the EDR and reconnect.
Message
Correct Start Position as earlier time then End Position
Cause
Start position is set after End Position.
Measure
Click CLEAR and reset the Start position and End Position.
Message
Directory (or File) is not found
Cause
1. Selected directory does not exist.
2. Directory or File name input is incorrect.
Measure
1. Make a new directory.
2. Check the input date.
Message
Day/Time Search disabled
Cause
Input date or time is incorrect.
Measure
Try again after correcting the data.
NOTES:
-- Java must be installed into your PC through the web site of Sun Microsystems.
-- You must acknowledge that the use of this software is at your own risk. Although this software
has been tested, ELMO will not warrant the performance or result you may obtain by using this
software with your network.
software with your network.
-- Only one PC can control this program. If another PC accessed to the EDR-X1 while your PC is
connected to it, your connection will be terminated.
-- It is recommended that you exit all other applications (such as IE), before you start this program
to make the transactions faster.
-- The image captured and saved to the PC is a JPEG file. The JPEG image has a size of 720 x
248m pixels. You can pull it only to vertical direction by 200% by using image-editing software
such as Microsoft photo editor*, or Adobe Photoshop*, etc, to change it to normal picture size.
such as Microsoft photo editor*, or Adobe Photoshop*, etc, to change it to normal picture size.
*Microsoft Photo Editor and Adobe Photoshop are registered trademarks of their respective
companies.