Avaya merlin plus Guia Do Utilizador

Página de 36
ERASING
You can decrease the time allocated for one announcement to lengthen the
ANNOUNCEMENTS AND
time for another provided the total time for all announcements equals 64 seconds.
REALLOCATING
For example, you can add 25 seconds to the day announcement if you are not
ANNOUNCEMENT TIMES
using the night announcement. To do this, you would use the procedure
below to allocate 50 seconds to the day announcement and 00 seconds to the
night announcement.
CAUTION:
Whenever you reallocate time to any announcement, you erase
1
2
3
4
5
6
7
8
all announcements that are already recorded. 
Select an outside line and dial a telephone number that is answered by
your MERLIN Attendant.
NOTE: 
If you are programming from a remote location using a single-line
standard Touch-Tone phone, enter only one pound sign (#) for
every two pound signs ( # # ) that appear in a programming
command.
Wait for an answer.
Dial * followed immediately by your authorized caller code and # #.
The two-beep confirmation tone sounds.
Dial *49.
NOTE:
If you want to erase the announcements without reallocating
time, skip to step 6.
Perform all the steps below even if you are not using all the
announcements. For example, if you do not use the night announcement,
enter 00. Be sure the total time allocated for 
all 
announcements equals 64
seconds.
a Dial two digits representing the maximum length in seconds for the
day announcement.
b Dial two digits representing the maximum length in seconds for the
night announcement.
c Dial 00 to represent the maximum setting for the transfer
announcement. (This announcement is never used with the
MERLIN Plus system.)
d Dial two digits representing the maximum length in seconds for the
hold announcement.
Dial ##.
The two-beep 
confirmation tone sounds.
Continue programming or exit authorized caller mode by dialing * # #.
NOTE: 
If you have more than one MERLIN Attendant, you may transfer
to each one by dialing the intercom numbers assigned to them—
usually 11, 12, and 13. Follow the procedures in this section to
program every MERLIN Attendant identically.
To disconnect, dial ##.
Changing the Current Settings  2-9