KitchenAid 24" Double Wall Oven with True Convection Utilização E Cuidado

Página de 32
12
OVEN CAVITY
Do not use oven cleaners.
Food spills should be cleaned after the oven cools. At high 
temperatures, foods react with porcelain and staining, etching, 
pitting or faint white spots can result.
Cleaning Method:
Self-Cleaning cycle:
 
See “Self-Cleaning Cycle” first.
Oven Lights
The oven lights are standard 40-watt appliance bulbs. Before 
replacing, make sure the oven is cool and the controls are turned 
Off.
To Replace:
1. Disconnect power.
2. Turn the glass bulb cover in the back of the oven 
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, and then bulb cover by turning clockwise.
5. Reconnect power.
PROBLEM SOLVER
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer 
to the warranty page in this manual and scan the code there with your mobile device, or visit http://kitchenaid.custhelp.com. In Canada, 
visit http://www.kitchenaid.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
KitchenAid Brand Home Appliances
 
Customer eXperience Center
 
553 Benson Road
 
Benton Harbor, MI 49022-2692
In Canada:
KitchenAid Brand Home Appliances
 
Customer eXperience Centre
 
200 - 6750 Century Ave.
 
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
PROBLEM
POSSIBLE CAUSES AND/OR SOLUTIONS
Nothing will operate
Oven isn’t wired properly - See the Installation Instructions.
Household fuse is blown, or a circuit breaker is tripped - Replace the fuse or reset the circuit breaker. 
If the problem continues, call an electrician.
The control displays an F9 or F9 E0 error code - The electrical outlet in the home may be miswired. 
Contact a qualified electrician to verify the electrical supply.
Oven will not operate
Delay Start is set - See the “Cook Time” section.
Control Lock is on - Press and hold START or START LOWER for 3 seconds to unlock.
Control is in Demo Mode - See the “Electronic Oven Controls” section. Demo Mode is used for display 
models in a showroom.
Electronic oven control set incorrectly - See the “Electronic Oven Controls” section.
Oven temperature too high 
or too low
Oven temperature needs adjustment - See “Oven Temperature Control” in the “Electronic Oven 
Controls” section.
Display shows messages
Power failure (display shows flashing time) - Press CANCEL or CANCEL UPPER to clear the display. 
On some models, reset the clock, if needed. See the “Clock/Tools” keypad feature in the “Feature Guide” 
section.
Error code (display shows letter followed by number) - Press CANCEL or CANCEL UPPER to clear 
the display. See “Control Display” in the “Electronic Oven Controls” section. If it reappears, call for 
service. See the “Warranty” section for contact information.
Clean cycle did not work 
on all spills
Several cooking cycles between Clean cycles or spills on oven walls and doors - Run additional 
Clean cycles. The affresh
®
 Kitchen and Appliance Cleaner can be used for stubborn soils. See the 
“Accessories” and “Self-Cleaning Cycle” sections for more information
.