Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Programa

(NETGEAR Switch)#show ip helper statistics

DHCP client messages received.................. 8

DHCP client messages relayed................... 2

DHCP server messages received.................. 2

DHCP server messages relayed................... 2

UDP client messages received................... 8

UDP client messages relayed.................... 2

DHCP message hop count exceeded max............ 0

DHCP message with secs field below min......... 0

DHCP message with giaddr set to local address.. 0

Packets with expired TTL....................... 0

Packets that matched a discard entry........... 0

Open Shortest Path First commands are supported on the 
M4300 series switches only.

This section describes the commands you use to view and configure Open Shortest Path 
First (OSPF), which is a link-state routing protocol that you use to route traffic within a 
network. This section contains the following subsections:

Use this command to enter Router OSPF mode. 

Format

router ospf

Mode

Global Config