Netgear M4300-24X24F (XSM4348S) - Stackable Managed Switch with 48x10G including 24x10GBASE-T and 24xSFP+ Layer 3 Guia Do Administrador
Port Routing
77
Managed Switches
b. Scroll down and select the interface 1/0/5 check box.
Now 1/0/5 appears in the Interface field at the top.
c. Enter the following information:
•
In the IP Address field, enter 192.150.5.1.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
Add a Default Route
When IP routing takes place on a switch, a routing table is needed for the switch to forward
the packet based on the destination IP address. The route entry in the routing table can
either be created dynamically through routing protocols like RIP and OSPF, or be manually
created by the network administrator. The route created manually is called the static or
default route.
the packet based on the destination IP address. The route entry in the routing table can
either be created dynamically through routing protocols like RIP and OSPF, or be manually
created by the network administrator. The route created manually is called the static or
default route.
A default route is used for forwarding the packet when the switch cannot find a match in the
routing table for an IP packet. The following example shows how to create a default route.
CLI: Add a Default Route
Note:
IP subnet 10.10.10.0 should be configured using either port routing
(
(
(FSM7338S) (Config) #ip route default?
<nexthopip> Enter the IP Address of the next router.
(FSM7328S) (Config)#ip route default 10.10.10.2