Netgear S3300-28X (GS728TX) - ProSAFE S3300 Smart Switch Series Guia Do Administrador
Maintenance
297
S3300 Smart Switch
Dual Image
From the Dual Image link, you can access the following pages:
•
•
Dual Image Configuration
Use the Dual Image Configuration screen to select which image to load during the next boot
cycle, configure an image description, or delete an image.
cycle, configure an image description, or delete an image.
To change the image that loads during boot-up:
1.
Select Maintenance > File Management > Dual Image > Dual Image Configuration.
2.
From the Image Name list, select the image that is not the image shown in the
Current-active field.
Current-active field.
The Current-active field displays the name of the active image.
3.
From the Unit Number list, select the specific unit number or All units to configure.
4.
(Optionally) In the Image Description field, specify a name for the selected image.
5.
Next to Activate Image, select the check box.
6.
Click the Apply button.
Note:
After activating an image, you must perform a system reset of the
switch to run the new code. The switch continues running the image
shown in the Current-active field until the switch reboots.
shown in the Current-active field until the switch reboots.
To delete an image:
1.
From the Image Name list, select the image that is not the image shown in the
Current-active field.
Current-active field.
You cannot delete the active image.
2.
Next to Delete Image, select the check box.
3.
Click the Apply button.
Dual Image Status
The Dual Image Status screen shows information about the active and backup images on the
system.
system.
To view dual image status information, select Maintenance > File Management > Dual
Image > Dual Image Status
Image > Dual Image Status