Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Guia Do Administrador

ICMP Rate Limiting, set this field to 0.The valid Rate Interval must be in the range 0 to 

2147483647 micro seconds.

In the ICMPv6 Rate Limit Burst Size field, specify the number of ICMP error packets 

allowed per burst interval. This value controls the ICMP error packets. Default burst size is 

100 packets. Valid Burst Size must be in the range of 1 to 200. 

In the IPv6 MTU field, specify in bytes the maximum Transmitted packet size for IPv6 

routing. This must be in the range of 1280 to 9000. The default setting is 1500 bytes.

Click Apply to send the updated configuration to the switch. Configuration changes take 

effect immediately.

The Route table contains all the IPv6 routes, static and non-static that exist on the device.



Click Routing

> IPv6 > Basic > Route Table.

Enter the following fields for the route:

IPv6 Prefix. Enter the network prefix. 

Prefix Length. Enter the network length.

Next Hop IPv6 Address Type. Select either Link Local or Global

.

Next Hop IPv6 Address. Enter the next hop IPv6 address for the route

.

Interface. Enter the outgoing IPv6 routing VLAN Interface to use when forwarding 
traffic to the destination

.

Preference. Enter the route preference of this route

.

Select the IPv6 Route Table to display.

In the Routes Displayed list, select from the following:

All Routes. Shows all best active IPv6 routes.

All Static Routes. Shows the static routes configured by the users.

The fields described above are displayed for the routes. In addition, the following fields 
are described:

Protocol. How route was created. The following options are available:

Static. Manually defined.

ND (Neighbor Discovery). Discovered by ND protocol.

Connected. Route was derived from a manually-configured device's IPv6 
address.

Next Hop Interface. Enter the network length.

Click Update to update the page with the latest information on the switch.