Netgear XS728T – ProSAFE® 10 Gigabit Smart Managed Switch Guia Do Administrador
Routing
95
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
VLAN Configuration
To configure IPv6 settings on VLAN interfaces:
1.
Click Routing
> IPv6 > Advanced > VLAN Configuration.
2.
Select the check box next to the VLAN Interface for which data is to be displayed or
configured. All VLAN interfaces are valid.
3.
Select Enable or Disable in the IPv6 Admin Mode list. When IPv6 admin mode is enabled,
the interface is capable of IPv6 operation. The default value is Disable.
4.
In the Stateless Address AutoConfig Mode list, select to Enable or Disable Stateless
Address AutoConfig mode on an interface. The default value is disable.
5.
In the Duplicate Address Detection Transmit field, specify the number of duplicate
address detection (DAD) transmits on an interface. DAD transmits values must be in the
range 0 to 600. The default is 1.
6.
Specify the router advertisement Life Time Interval sent from the interface. This value must
be greater than or equal to the maximum advertisement interval. 0 means do not use the
router as the default router. The range of router life time is 0 to 9000. The default is 1800.
7.
In the Adv NS Interval field, specify the retransmission time field of router advertisement
sent from the interface. A value of 0 means the interval is not specified for the router. The
range of neighbor solicit interval is 1000 to 4294967295. The default is 0.
8.
In the Adv Reachable Interval field, specify the router advertisement time to consider
neighbor reachable after ND confirmation. The range of reachable time is 0 to 3600000. The
default is 0.
9.
Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface. The range of maximum advertisement interval is 4 to
1800. The default value is 600.
10.
In the Adv Manage Config Flag list, select Enable or Disable to specify the router
advertisement of the manage configuration flag. Default value of this flag is Disable.
11.
In the Adv Other Config Flag list, select Enable or Disable to specify the router
advertisement of the other stateful configuration flag. Default value of this flag is Disable.
12.
In the Adv Suppress Flag list, select to Enable or Disable router advertisement
suppression on an interface. The default value of this flag is Disable.
13.
In the Destination Unreachables list, select to Enable or Disable the Mode of Sending
ICMPv6 Destination Unreachables on this interface. If Disabled, then this interface will not
send ICMPv6 Destination Unreachables. By default, the IPv6 Destination Unreachables
mode is Enable.
14.
Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.