Netgear GS752TP - 52PT GE POE SMART SWITCH Guia Do Administrador

Página de 275
Managing Device Security 
191
 GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
4. 
In the Binding Configuration area, the Inbound only packet filtering direction for an ACL is 
selected in the Direction field.
5. 
In the Port Selection Table area, specify the list of all available valid interfaces for ACL 
mapping. 
All non-routing physical interfaces and interfaces participating in the LAG are listed.
6. 
To add a rule to the ACL, select the check box next to the ACL, then click ADD.
7. 
Click APPLY to update the switch with the new settings.
Configuration changes take effect immediately.
MAC ACL
A MAC ACL consists of a set of rules that are matched sequentially against a packet. When a 
packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken 
and the additional rules are not checked for a match.
The steps for defining a MAC ACL and applying it to the switch are described in the following 
sections:
1. 
2. 
3. 
 screen to assign the ACL by its ID number to a port. 
4. 
Optionally, use the 
To configure a MAC ACL:
1. 
Select Security 
 ACL > Basic > MAC ACL
Destination IPv6 L4 
Port
• 
Destination L4 port (protocol). Specify the destination IPv6 L4 port protocol. 
• 
Destination L4 port (value). Specify the destination IPv6 L4 port value.
Source IPv6 L4 Port
• 
Source L4 port (protocol). Specify the source IPv6 L4 port protocol. 
• 
Source L4 port (value). Specify the source IPv6 L4 port value.
ACL Based on
Fields