KitchenAid 36" Designer Commercial-Style Hood Utilização E Cuidado

1. Install damper on top of the exhaust opening. Check that the 

damper opens freely. On 48" (121.9 cm) models, install 
2 dampers.

2. Connect the vent system and seal all connections with 

clamps.

1. Slightly spread the sides of the cover apart and hook them 

behind the chimney mounting brackets.

2. Attach the cover to the brackets with 4 flat head screws.

3. Securely tighten screws.

1. Slightly spread the sides of the cover apart and hook them 

behind the upper chimney.

2. From inside the range hood, use the 4 Phillips washer head 

screws to attach the lower chimney cover to the canopy of 
the range hood.

3. Securely tighten screws.

NOTE: Use 2 hands to install filter, one to pull and turn the knob, 
the other to hold the filter in place so that it doesn’t fall.

1. Insert back edge of filter into rear channel of the filter 

opening.

2. Pull out on knob and turn counterclockwise, position front 

edge into place and release knob.

3. Repeat for remaining filters.

1. Check operation of the range hood by turning on the power.

2. The range hood controls are located on the right-hand 

underside of the range hood.

3. Move the light switch to “1” position. The light should turn on.

4. Move fan switch to “On” position. The fan should operate.

5. Move the fan speed switch to “1” position for low speed, “2” 

position for medium speed, or “3” position for high speed.

6. Move fan and light switches to “Off” position to turn fan and 

light off.

7. If range hood does not operate, check to see whether a 

circuit breaker has tripped or a household fuse has blown. 
Disconnect power supply and check that the wiring is 
correct.

NOTE: To get the most efficient use from your new range hood, 
read the “Range Hood Use” section.

A

A

A

A

B

C