Xerox Xerox Secure Access Unified ID System Support & Software Guia Do Administrador
Configuration & Management
Xerox Secure Access Administration Guide
27
4. Click OK to save the settings.
Note:
If Secure Access detects that the device is Custom-services enabled, and you made changes
in the Devices dialog, a popup window will appear:
• If the Release My Documents extension is not currently installed on the device, the prompt “Do
you want to enable Follow-You Printing?” appears.
• If the Release My Documents extension is installed on the device, the prompt asks “Do you
want to keep Follow-You Printing enabled?”
Associate the MFP with a Secure Access Authentication Device
Note:
If you are using a Secure Access USB Card reader you can skip this step.
When you initially power on an Authentication Device connected to the network, the DCE registers the
device. The device displays in the Secure Access Manager as an unassigned Secure Access
Authentication Device. You then need to associate each MFP with a specific Secure Access
Authentication Device. Use the Tear Sheet (see the Installation Guide) you filled in during the
hardware setup to map each Authentication Device to the appropriate MFP.
1. In the Secure Access Manager, click Devices, then select the MFP you want to configure.
2. In the Physical Device Summary dialog, drop-down the Hardware Address list.
3. Using your tear sheet as a reference, locate the correct MAC Address of the Authentication Device
device. The device displays in the Secure Access Manager as an unassigned Secure Access
Authentication Device. You then need to associate each MFP with a specific Secure Access
Authentication Device. Use the Tear Sheet (see the Installation Guide) you filled in during the
hardware setup to map each Authentication Device to the appropriate MFP.
1. In the Secure Access Manager, click Devices, then select the MFP you want to configure.
2. In the Physical Device Summary dialog, drop-down the Hardware Address list.
3. Using your tear sheet as a reference, locate the correct MAC Address of the Authentication Device
that will control access to this particular MFP.
4. Click OK to save the changes.
Initialize Secure Access device
The Secure Access device is initialized automatically when it is first
configured. If the MFP is changed, initialize the Secure Access device by
clicking this button. A pop-up window will appear to confirm that the
initialization was successful.
configured. If the MFP is changed, initialize the Secure Access device by
clicking this button. A pop-up window will appear to confirm that the
initialization was successful.
Note:
You can click this button to install the Release My Documents custom
service. See
page 39 for more information.
Behavior
If you are using the Secure Access Port Monitor to enable Follow-You
Printing, you can select from one of two release options:
•
Printing, you can select from one of two release options:
•
At assigned control terminal: The user must swipe their card at the
MFP to release documents sent to that device.
MFP to release documents sent to that device.
•
Release documents from pull group: After authentication, the user
can follow the instructions on the front panel to select queued
documents from a specific pull group. For details, see
can follow the instructions on the front panel to select queued
documents from a specific pull group. For details, see
If you are using the Windows port monitors, these settings have no effect.
Setting
Description