Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP
13
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(52)SE
515765-003
Documentation Notes
Documentation Notes
This section describes documentation notes related to this IOS release.
References to Cisco IOS Release 12.2(25)SE
These older documents refer to Release 12.2(25)SE. The correct release is Release 12.2(25)SE1.
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Software Configuration Guide,
Cisco IOS Release 12.2(25)SE
Cisco IOS Release 12.2(25)SE
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Command Reference Guide,
Cisco IOS Release 12.2(25)SE
Cisco IOS Release 12.2(25)SE
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class System Message Guide, Cisco
IOS Release 12.2(25)SE
IOS Release 12.2(25)SE
Open Caveats
Open IOS Caveats
These severity Cisco IOS configuration caveat applies to the CGESM switch:
•
CSCsz18634
On a switch running Cisco IOS release 12.2(46)SE, the output of the show interfaces privileged
EXEC command shows 0 packets for port channel input and output rates.
EXEC command shows 0 packets for port channel input and output rates.
The workaround is to reload the switch by entering the reload privileged EXEC command.
•
CSCtc02635
On switches running Cisco IOS release 12.2(50)SE3 running MAC authentication bypass with
multidomain authentication (MDA, IP phones connected to a port might not be able to regain
network connectivity in the VOICE domain if the session times out and all RADIUS servers are
unreachable.
multidomain authentication (MDA, IP phones connected to a port might not be able to regain
network connectivity in the VOICE domain if the session times out and all RADIUS servers are
unreachable.
There is no workaround.
Open HP Caveats
These are the HP severity 2 open caveats for this release:
•
rQm 263546
Disconnecting the cable from the console port does not end a Telnet session. If you are in privileged
EXEC mode when you remove the cable, the next session that is started on the console port will also
be in privileged EXEC mode.
EXEC mode when you remove the cable, the next session that is started on the console port will also
be in privileged EXEC mode.
The workaround is to end the session before you remove the cable.