Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP
14
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(52)SE
515765-003
Resolved Caveats
•
rQm 266129
If you power on a switch that does not have a config.txt file (the factory default file) and leave the
switch on for few hours, the switch console appears to be stalled during setup.
switch on for few hours, the switch console appears to be stalled during setup.
The workaround is to reload the switch before you continue to configure it.
Resolved Caveats
•
CSCsw68528
When you use the show mvr interface interface members privileged EXEC command to view the
Multicast VLAN Registration (MVR) interface group status, the switch incorrectly displays the
status ACTIVE for port members that are not connected.
Multicast VLAN Registration (MVR) interface group status, the switch incorrectly displays the
status ACTIVE for port members that are not connected.
The workaround is to use the show mvr interface interface or show mvr members privileged
EXEC command to display the port MVR status.
EXEC command to display the port MVR status.
•
CSCsx71632
When VLAN-based quality of service (QoS) is enabled and then disabled on an interface by entering
the mls qos vlan-based interface configuration command followed by the no version of the
command, the port policy is not applied properly and could result in undefined behavior for packets
matching the port policy.
the mls qos vlan-based interface configuration command followed by the no version of the
command, the port policy is not applied properly and could result in undefined behavior for packets
matching the port policy.
The workaround is to remove the port policy by entering the no service-policy input
policy-map-name interface configuration command and then reapply it to the interface.
policy-map-name interface configuration command and then reapply it to the interface.
•
CSCsx78068
If you enable 802.1Q native VLAN tagging by entering the vlan dot1q tag native global
configuration command and then change the native VLAN ID on an ingress trunk port by entering
the switchport trunk native vlan vlan-id interface command, untagged traffic is forwarded instead
of being dropped.
configuration command and then change the native VLAN ID on an ingress trunk port by entering
the switchport trunk native vlan vlan-id interface command, untagged traffic is forwarded instead
of being dropped.
The workaround is to use one of these methods:
–
Enter a shutdown followed by a no shutdown interface configuration command on the trunk
port.
port.
–
Disable and then reenable native VLAN tagging by entering the no vlan dot1q tag native
global configuration command followed by the vlan dot1q tag native command.
global configuration command followed by the vlan dot1q tag native command.
•
CSCsy90265
If you repeatedly enter the show tech-support privileged EXEC command, the switch might leak
memory and, in some cases, shut down.
memory and, in some cases, shut down.
The workaround is to reload the switch to clear the memory after repeated use of the show
tech-support command.
tech-support command.
•
CSCta57846
The switch unexpectedly reloads when copying a configuration file from a remote server or from
flash memory containing logging file flash:
flash memory containing logging file flash:
The workaround is to enter the logging file flash:filename global configuration command to
configure logging to flash instead of copying to flash.
configure logging to flash instead of copying to flash.