Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Guia Da Instalação
10
Upgrading the Cisco ONS 15600 SDH to Release 9.0
78-18839-01
DLP- U442 Download the ONS 15600 SDH Release 9.0 Software
DLP-U442 Download the ONS 15600 SDH Release 9.0 Software
Note
The download task does not affect traffic because the active software continues to run at the primary
RAM location; therefore, you can download the software at any time.
RAM location; therefore, you can download the software at any time.
Step 1
If CTC is not already running, start CTC.
Step 2
In node view, click the Alarms tab.
Step 3
Verify that the alarm filter is not on. Click the Filter tool at the lower-left of the window.
Step 4
The Alarm Filter dialog box appears. Click the check boxes to deselect any selections in the Show
Severity section of the General tab.
Severity section of the General tab.
Step 5
On the Alarms tab, check all nodes for existing alarms. Resolve any outstanding critical alarms before
proceeding. If necessary, refer to the Cisco ONS 15600 SDH Troubleshooting Guide.
proceeding. If necessary, refer to the Cisco ONS 15600 SDH Troubleshooting Guide.
Step 6
If the TSC card in Slot 5 is the active TSC, you will need to perform a soft reset to make the TSC in
Slot 10 the active TSC. Select Slot 5, then right-click to display a shortcut menu. Click the Soft reset
Card button. The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.
Slot 10 the active TSC. Select Slot 5, then right-click to display a shortcut menu. Click the Soft reset
Card button. The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.
Note
The TSC card can take several minutes to reboot.
Step 7
If not in node view, open the View menu and choose Go to Home View to go to the node view.
Step 8
Click the Maintenance tab and then click the Software button.
Step 9
Click the Download button. The Download Selection dialog box appears.
Step 10
Click the Browse button.
Step 11
In the Open dialog box, navigate to the software package files on the ONS 15600 SDH software CD or
on your hard drive, if you are working from a local copy.
on your hard drive, if you are working from a local copy.
Step 12
Select the file with the PKG extension and click the Open button.
Step 13
In the Download Selection dialog box, verify that the node is selected, then click OK. The software
begins downloading to the active TSC card, and the TSC card in Slot 10 is highlighted.
begins downloading to the active TSC card, and the TSC card in Slot 10 is highlighted.
Step 14
Click the History tab to view the conditions:
1.
Downloading (approximately 10 to 20 minutes)
2.
System Upgrade in progress (approximately 3 to 5 minutes)
Step 15
Click the Maintenance tab and then click the Software button. The Download Status column shows the
percentage of the completion of the upgrade progress.
percentage of the completion of the upgrade progress.
When the Download Status column is empty, the software has finished loading.
Purpose
This task downloads the software to the ONS 15600 SDH nodes.
Tools/Equipment
PC or UNIX workstation
Prerequisite Procedures
Required/As Needed
Required
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Superuser