Cisco Cisco Agent Desktop 8.5 Guia Da Instalação
CAD Configuration Setup Utility
February 21, 2013
55
Entering Configuration Data in Initial Mode
After the desktop services are installed, CAD Configuration Setup starts automatically
and displays the CAD Base services location dialog box.
and displays the CAD Base services location dialog box.
You can set up Directory Services replication between two installations of the base
services, which includes Directory Services. To do this, you install the base services on
the primary server and complete the CAD Configuration Setup steps, then do the
same on the secondary server, at that time identifying the computer that hosts the
primary Directory Services.
services, which includes Directory Services. To do this, you install the base services on
the primary server and complete the CAD Configuration Setup steps, then do the
same on the secondary server, at that time identifying the computer that hosts the
primary Directory Services.
If your system does not include Directory Services replication, follow the procedure for
entering configuration data on the primary base services computer only.
entering configuration data on the primary base services computer only.
NOTE: Directory Services replication can be set up at a later time by
running CAD Configuration Setup in update mode on the secondary
base services computer and entering information in the Replication
Setup step.
running CAD Configuration Setup in update mode on the secondary
base services computer and entering information in the Replication
Setup step.
Configuring a Single or Primary Server in a Replicated System
Complete the following procedure if you are running CAD Configuration Setup in initial
mode on a single server system or on the primary server in a replicated system.
mode on a single server system or on the primary server in a replicated system.
To enter configuration data in initial mode on the primary base services computer:
1. Configuration Setup starts automatically and displays the CAD Base Services
Location dialog box (
).
2. Enter the IP address of the primary Directory Services and then click OK.
Figure 5.
CAD Base Services Location dialog box