Cisco Cisco Agent Desktop 8.5 Guia Da Instalação
CAD Configuration Setup Utility
February 21, 2013
81
Services Configuration
The Services Configuration step only appears during update mode.
If the computer has more than one IP address, select the IP address of the NIC used
to connect to the LAN—it must be accessible by the client desktops.
to connect to the LAN—it must be accessible by the client desktops.
To enable CAD automated updates, select Yes. Automated updates cause Agent
Desktop, Supervisor Desktop, and Desktop Administrator to look for newer versions
every time they start. If one is found, the update process is run automatically.
Desktop, Supervisor Desktop, and Desktop Administrator to look for newer versions
every time they start. If one is found, the update process is run automatically.
NOTE: To connect to Unified CM, the BIPPA service must have
identical user IDs and passwords configured in this step and in
Unified CM. You can complete the fields in this step before
configuring the user in Unified CM. To configure credentials in
Unified CM, see
identical user IDs and passwords configured in this step and in
Unified CM. You can complete the fields in this step before
configuring the user in Unified CM. To configure credentials in
Unified CM, see
.If you
change any of these settings, you must restart all CAD services to
ensure that the change is registered with them properly.
ensure that the change is registered with them properly.
Figure 18.
Services Configuration