Cisco Cisco Agent Desktop 8.5 Guia Da Instalação
CAD Configuration Setup Utility
February 21, 2013
83
SNMP Configuration
The SNMP Configuration step appears only during the update mode if the Microsoft
Simple Network Management Protocol (SNMP) service is installed on the CAD services
server.
Simple Network Management Protocol (SNMP) service is installed on the CAD services
server.
If you select the Enable SNMP Trap Generation check box, INFO and higher error
messages are sent from the CAD services server to the IP addresses configured in the
Destination pane. Use the Add, Edit, and Remove buttons to manage the list of
destination IP addresses.
messages are sent from the CAD services server to the IP addresses configured in the
Destination pane. Use the Add, Edit, and Remove buttons to manage the list of
destination IP addresses.
To install the SNMP service, open the Add or Remove Programs control panel, then
click Add or Remove Windows Components. Select Management and Monitoring Tools
from the list of components, then select Simple Network Management Protocol.
click Add or Remove Windows Components. Select Management and Monitoring Tools
from the list of components, then select Simple Network Management Protocol.
SNMP allows you to monitor and manage a network from a single workstation or
several workstations, called SNMP managers. SNMP is actually a family of
several workstations, called SNMP managers. SNMP is actually a family of
Figure 19.
SNMP Configuration