Cisco Cisco Agent Desktop 8.5 Guia Da Instalação

The CAD Configuration Setup tool is used to enter the service setup information 
needed for a successful CAD installation.

CAD Configuration Setup is launched automatically after you install the CAD services 
in Initial Mode. Any time you launch the Configuration Setup tool after this, it is 
launched in Update Mode.

In Initial Mode, you must complete all windows in sequence. If you do not complete a 
window, you cannot go forward to the next window. You can go backwards and 
revise a window you already completed.

Once you have completed all the windows, the Save button on the toolbar is enabled. 
You must click Save in order to correctly configure your CAD services. If you do not 
click Save, but opt to cancel the configuration setup process, the next time you start 
the tool you will have to repeat the configuration process and complete all windows.

After the Desktop services are installed, Configuration Setup starts automatically and 
displays the CAD Directory Services dialog box.

1. Configuration Setup starts automatically and displays the CAD Directory 

Services dialog box (see 

). 

2. Enter the IP address of the primary Directory Services and then click OK. 

The System IPCC dialog box appears (see 

).