Cisco Cisco Aironet 350 Wireless LAN Client Adapter

You must have a Cisco Aironet 340 or 350 series client adapter (PC card, LM card, or PCI client adapter) 
to install firmware version 4.25.10.

If you use Network-EAP authentication on your wireless network, your client devices and infrastructure 
devices (access points and bridges) must use the same 802.1x protocol draft. Client firmware release 
4.25.10 is Draft 10 of the 802.1x protocol standard. Therefore, if client devices use this version of 
firmware, an access point to which they will associate must be configured to also use Draft 10. The table 
below lists firmware versions for Cisco Aironet products and the drafts with which they comply.

If your clients and infrastructure devices do not have matching 802.1x protocol drafts, upgrade the 
firmware in these devices to versions with the same draft number. However, if your access points or 
bridges are using firmware version 11.06, you can use their Authenticator Configuration page to select 
the draft of the 802.1x protocol that they should use. To set the draft for your access points or bridges, 
follow the instructions in the Release Notes for Cisco Aironet Access Points for firmware version 11.06. 
You can access these Release Notes at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/accsspts/ap350rn/index.htm

4.13

—

x

—

4.16

—

x

—

4.23

—

x

—

4.25 and later

—

—

x

8.58

—

x

—

8.61 and later

—

—

x

11.05 and earlier

—

x

—

11.06 and later

1

1.

The default draft setting in access point and bridge firmware version 11.06 and later is 
Draft 10.

—

x

x

11.06 and later

—

x

x