Cisco Cisco FastHub 412M 10 100 Repeater
6
Removing a Module
Removing a Module
Caution
The modules are not hot-swappable. Be sure to power off the hub before installing a module in the
hub or removing it.
To remove a module, follow these steps:
Step 1
Power off the hub.
Step 2
Disconnect the cable from the module port.
Step 3
Loosen the screws attaching the module to the hub.
Step 4
Pull the module out of the slot.
Step 5
Replace the blank faceplate over the slot.
Step 6
Insert and tighten the screws on the faceplate.
Step 7
Power on the hub.
Connecting to the Module Port
Note
The FastHub 400 10/100 Series Installation and Configuration Guide provides information
about Ethernet network guidelines, including determining acceptable cable distances between a
FastHub 400 model and attached network devices.
FastHub 400 model and attached network devices.
Warning
Class 1 laser product.
Warning
Avoid exposure to the laser beam.
Caution
When installing a 100BaseFX switched uplink module, do not remove the rubber plugs from the
fiber-optic port or the rubber caps from the fiber-optic cable until you are ready to connect the cable. The
plugs and caps protect the fiber-optic port and cable from contamination.
plugs and caps protect the fiber-optic port and cable from contamination.