Escalade Sports 2l-6540-00 Manual Do Utilizador

30

21

1/8''

22

33

3

1

1

33

This set of holes grouped close
together goes toward the top.

4a. Attach leg posts #3 to the inside face of

metal leg facades #1 on both leg assem-

blies (from steps 1 & 2). Use two

carriage bolts #30, two washers #22

and two locknuts #21 per leg post.

NOTE: There is a set of holes at one

end of the leg posts that are grouped

close together. Make sure that these

holes go to the top of the wooden

posts. About 1/8 inch of leg posts #3

will extend below the metal facade #1.

(Figure 2)

4b.Once the leg post is securely fastened,

tighten the four bottom screws #33 on

the leg panels.

3

1. Open hardware kits and sort

hardware into "like" groups using

hardware identifier provided in

your table manual. CAUTION:

2. Attach two wooden leg panels #2

(be sure wood grain faces out) to

the inside of two leg facades #1

using six screws #33, six washers

#35 and six locknuts #34 per leg

panel.  Make sure that dimension

B is at the bottom of the leg panel.

(See Figure 1)

3. Repeat step 2 to put together other

leg assembly.