Pelco DX4500 Manual Do Utilizador
12
C2676M (9/07)
REMOVING THE MOUNTING BASKET
If a HDD is already installed, go to step 1. If a HDD is not yet installed, go to step 2.
1. To remove the SATA HDD power connector and data cable do the following:
a.
Grasp the top and bottom of the SATA power connector and carefully and simultaneously pull
straight back on the connector. Refer to Figure 8.
straight back on the connector. Refer to Figure 8.
b.
Grasp each side of the SATA data connector and carefully and simultaneously pull straight
back on the connector. Refer to Figure 8.
back on the connector. Refer to Figure 8.
Figure 8. Removing the Data and Power Cables
2. To remove the HDD mounting basket do the following:
a.
Using a Phillips screwdriver, unscrew the four screws that attach the mounting basket to the
chassis. Refer to Figure 9.
chassis. Refer to Figure 9.
b.
Gently lift the basket up and out with the drive(s) attached. Be careful not to force the basket
free or to disturb other components inside the unit. Refer to Figure 9.
free or to disturb other components inside the unit. Refer to Figure 9.
Figure 9. Removing the Mounting Basket