MINOLTA magicolor 2 Manual Do Utilizador

Introduction

QMS magicolor 2 Op

eration

5-2

Introduction

This chapter describes how to handle and clean the printer. 

Blurred or splotchy prints and paper jams can result from dusty printer 
parts. Regular cleaning takes only a few minutes and helps ensure 
print quality. Printer parts that require cleaning are the paper pick-up 
rollers and the outside surface of the printer.

Handling the Printer 

Handle the printer with care to preserve its life. Abuse may cause 
damage. Keep the following guidelines in mind:

n

Do not place anything on the top of the printer.

n

Avoid spraying cleaning solution directly on the printer’s surface; 
the spray could penetrate through the air vents of the printer and 
damage the internal circuits.

n

Be careful when cleaning the inside or removing paper jams, as 
the fuser assembly and other internal parts become very hot. 
Open the printer cover, and let the interior of the printer cool 
before handling the inside of the printer. 

n

Always close the printer covers gently. Never expose the printer 
to vibrations.

n

Do not cover the printer immediately after using it. Turn it off and 
wait until it cools down. 

n

Do not leave the printer open for any length of time, especially in 
well-lit places; light may damage the OPC belt cartridge.

n

Do not open the printer during printing and do not tap paper 
stacks on the printer.

n

Do not tilt, lubricate, or disassemble the printer.