Compustar model p1bamr Manual Do Utilizador

  

 

4 

When servicing or loaning your vehicle to others, the CompuStar Pro system should be placed in Valet 
mode. Valet mode prevents the system from remote starting and disables all alarm functions.        
IMPORTANT:  While in Valet mode the CompuStar will still lock and unlock power lock systems.   

1.  You can put the system into valet by turning the ignition key “on” and then “off” five 

times within 7 seconds. The parking lights will flash once to confirm the system is in 
valet mode. Shortly after the first flash, the parking lights will flash twice.   

 
2.  (Optional Feature) If your system is set up for a secure valet option, you will not be able to put the 

system into valet until the proper code has been entered with the secure valet switch. 

The only regular maintenance this system requires is remote control battery replacement.    
No programming is required when replacing the battery.  

First, remove the small Phillips screw located on the back of the remote. Once the screw has been 
removed, gently pull the remote apart being careful to not touch the circuit board. The P1BAMR requires 
two CR2016 batteries. These specialty batteries can be purchased from your local CompuStar dealer or 
an electronics store. 

 

Button 

Duration 

Additional 

Programming 

Required 

Function / Description 

1.0 
second 

no 

Lock/Arm. Tap again to Unlock/Disarm your vehicle 

 

3.5 
seconds 

no 

 Activates the remote start. Repeat and remote start will shut off. 

 
 

 
The remote transmitter functions have been predetermined and programmed from the factory. The single 
button configuration allows for keyless entry and/or remote start functionality. Although other CompuStar 
PRO systems have numerous button functions and capabilities, please keep in mind that your system 
has the option for future upgradeability to a 2-way system. 

When in range, and the button has been pressed, the remote bright blue LED will illuminate and vehicle’s 
parking lights will flash. For example, to send a remote start command from the P1BAMR, hold down the 
single button for 3.5 seconds. The remote bright blue LED will come on solid and then flash.