Compustar model p1bamr Manual Do Utilizador

  

 

6 

Reservation mode will be cancelled for the following reasons; 

•  You did not activate the parking brake prior to turning off the ignition. 

•  You pressed the foot brake after the key was removed from the ignition. 

•  You released the parking brake after the key was removed from the ignition. 

•  You entered valet mode, opened the vehicles door, hood, or trunk. 

Reservation mode settings can be programmed with Option 1-6. It is recommended that reservation 
mode settings are programmed by your local authorized CompuStar dealer. 
 
Default 1:  Locks doors when reservation mode is set. 
Option 2:  Does not lock doors when reservation mode is set. 
Option 3:  Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.  
This option will allow you to access the vehicles rear doors, trunk or hatch prior to the system setting 
reservation and passively locking/arming. 

The optional anti-grind/starter kill feature prevents you from accidentally grinding your vehicle’s starter 
motor when taking over with the key. This feature requires additional installation and programming. Also 
your dealer can program a basic security feature that prevents your vehicle from starting when it is 
locked/armed. Please see your dealer for more details. 

The optional Secure Valet Switch prevents the remote start from being put into valet mode through 
cycling the ignition on/off five times. The Secure Valet Switch is more secure than traditional toggle / 
valet switches because it requires a two digit code. Follow the below procedures to program your secure 
valet pass code:  
 
STEP 1: Turn on Option 3-10-III. (Dealer programmed option) 
 
STEP 2: Turn ignition key to the “on” position. 
 
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash 
rapidly with successful completion of this step. 
 
STEP 4: Enter the first digit of the desired two-digit pass code by depressing the switch the number of 
times that coordinates with the desired first number. For example, to enter 3, depress the switch 3 times, 
then wait. 
 
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash 
rapidly, enter your second number by repeating step 4. 
 
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 – 5 to enter 
your Secure Valet code.