Справочник Пользователя для Crestron cnxenet plus
CNX Enhanced Ethernet Expansion Card
Crestron CNXENET+
CNMSX Installation (1 of 3)
3
1
2
REAR PANEL
(REFERENCE ONLY)
2. Remove
six screws from each side of the control system.
3. Lift and remove control system top cover .
4. As shown below, remove six screws that secure I/O printed circuit
board to the control system.
CNMSX Installation (2 of 3)
8
7
4
5
6
REAR PANEL
(REFERENCE ONLY)
5. Slide the I/O printed circuit board toward the front panel of the
control system so that the rear connectors are clear of the rear panel
slots and reposition the I/O printed circuit board to gain access to the
LAN/DPA cover plate .
slots and reposition the I/O printed circuit board to gain access to the
LAN/DPA cover plate .
6. Using a #1 Phillips tip screwdriver, remove two screws and two
lock washers that secure the LAN/DPA cover plate to the control
system rear panel.
system rear panel.
7. From inside the control system, remove the LAN/DPA cover plate .
8. For older model control systems, carefully push the computer interface
ribbon cable aside to make room for the CNXENET+. For newer
systems, make sure that cable does not interfere with CNXENET+
placement.
systems, make sure that cable does not interfere with CNXENET+
placement.
4
• CNX Enhanced Ethernet Expansion Card: CNXENET+
Operations & Installation Guide – DOC. 8153A