omnitron-systems-technolo 10-100m Manual Do Utilizador

Management Options

iConverter, Serial Agent

 Network Management

 1:  Chassis and Module Management

 2:  Set Module Identifier

 Management Module Preferences

 3:  IP and Control Preferences

 4:  SNMP Preferences

 5:  Abandon Preference Changes

 6:  Save Preference Changes

 7:  Restore to Factory Defaults

 8:  Restart Management Module

 9:  Other Networking Features

 Management Module Maintenance

 10: Firmware Update

 11: Set Date/Time

 IP Address     = 192.168.1.220

 Chassis Number = 1

Enter Choice, (H)elp, E(x)it > 9

Other Networking Features Screen

iConverter, Serial Agent

 1:  Enable/Disable DHCP Client

Disabled

 2:  Enable/Disable Keep Alive Trap

Disabled

 3:  Keep Alive Trap interval (10-600 secs)

10

 4:  Enable/Disable SW1 Switch Block

Enabled

 5:  Serial Baud Rate

57600 bps

 6:  Enable/Disable VLAN Support

Disabled

 7:  VLAN ID (0-4095)

2

 8:  VLAN Priority (0-7)

7

 Enter Choice, Management Options Screen(0), (H)elp, E(x)it >

To enable DHCP client, select 1 at the Other Networking Features screen and follow the screen prompts
to enable DHCP.

To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then
select 6 and press <ENTER> to Save Preference Changes.

A Chassis Name, or sysName, can be assigned for identification of the 10/100M in the SNMP client.  The
name can be any 1-32 character alphanumeric string.

The Chassis Number can remain as 1 (factory default) when the 10/100M is installed without an iConverter
NMM in the same chassis.  When the 10/100M is installed in the same chassis as an NMM, then the 10/100M
must be set to the Chassis Number of the NMM.

To set the Chassis Number, select 4 at the IP and Control Preferences screen, press <ENTER> and follow
the instructions to enter the chassis number.

To set the Chassis Name, select 5 at the IP and Control Preferences screen, press <ENTER> and follow
the instructions to enter the chassis name.

Page 14