Jacuzzi j-300 j-335 Manual Do Utilizador

21

10. Leave spa cover open during this step to allow  

excessive chemical vapors to exit spa, protecting 

pillows and plastic knobs from chemical attack. If 

spa is indoors, open doors and windows for proper 

ventilation. Turn on all jet pumps for one hour, 

then place the massage selector knob in the  

center “combo” position and open all air controls. 

note: You will need to press the jets pump button(s) every 20 minutes 

since these functions have an automatic 20 minute time-out function that 

turns them off.

 

To decrease the risk of injury, drowning or entrapment, 

• 

never leave your hot tub unattended for any reason while 

the cover is open and accessible, especially to small chil-

dren and animals! 

Precautions should be taken to minimize your exposure 

• 

to chemical vapors (that could cause lung, brain, or skin 

damage).   

!

11.  Turn off power to the spa at the circuit breaker, then drain spa as 

outlined in Section 12.2 “Draining And Refilling” (page 33).

12. Fill spa until water covers all jets but does not touch the bottom of 

the lowest headrest. DO NOT OVERFILL.

CauTIon: To DeCrease BuIlD up on ComponenTs anD 

mInImIZe aCrYlIC DamaGe. 

Never fill with water from a water softener. If your water is extremely 

“hard”, it is preferable to fill half-way with hard water and the rest of 

the way with softened water. Water that is too soft can be corrosive 

to metal components.

13. Consult your authorized Jacuzzi dealer for chemical 

recommendations, then add chemicals to spa water to achieve a 

constant sanitizer reading within the levels recommended by the 

Association of Pool and Spa Professionals/USA printed on the inside 

cover of this manual.

14. Turn on all jet pumps when adding chemicals to ensure proper 

mixing and leave your spa cover open until the sanitizer level falls 

below 4.0 ppm to protect pillows and plastic knobs from chemical 

attack.