JVC KD-R888BT Manual Do Proprietário

ENGLISH

33

  Remedy

Bluetooth®

Phone sound quality 
is poor.

•  Reduce the distance between the unit and the Bluetooth 

device.

•  Move the car to a place where you can get a better 

signal reception.

Sound is being 
interrupted or skipped 
during playback of a 
Bluetooth audio player.

•  Reduce the distance between the unit and the Bluetooth 

audio player.

•  Turn off, then turn on the unit and try to connect again.
•  Other Bluetooth devices might be trying to connect to 

the unit.

The connected Bluetooth 
audio player cannot be 
controlled.

•  Check whether the connected Bluetooth audio player 

supports Audio/Video Remote Control Profile (AVRCP). 
(Refer to the instructions of your audio player.)

•  Disconnect and connect the Bluetooth player again.

“PLEASE WAIT”

  The unit is preparing to use the Bluetooth function. If 

the message does not disappear, turn off and turn on 
the unit, then connect the device again.

“NOT SUPPORT”

  The connected phone does not support Voice 

Recognition feature.

“ERROR”

  Try the operation again. If “ERROR” appears again, check 

if the device supports the function you have tried.

“H/W ERROR”

  Reset the unit and try the operation again. If “H/W 

ERROR” appears again, consult your nearest service 
center.

•  The unit can only be used with a 12 V DC power supply, negative ground.
•  Disconnect the battery’s negative terminal before wiring and mounting.
•  Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire 

(black) to prevent a short circuit.

•  Insulate unconnected wires with vinyl tape to prevent a short circuit.
•  Be sure to ground this unit to the car’s chassis again after installation.

•  For safety’s sake, leave wiring and mounting to professionals. Consult the car audio dealer.
•  Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during 

and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.

•  Do not connect the 

 wires of speakers to the car chassis or Ground wire (black), or connect 

them in parallel.

•  Connect speakers with a maximum power of more than 50 W. If the maximum power of 

the speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the 
speakers. (  23)

•  Mount the unit at an angle of less than 30º.
•  If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) 

to the terminal on the vehicle’s fuse box which provides 12 V DC power supply and is turned 
on and off by the ignition key.

•  Keep all cables away from heat dissipate metal parts.
•  After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are 

working properly.

•  If the fuse blows, first make sure the wires are not touching car’s chassis, then replace the old 

fuse with one that has the same rating.

2  Connect the wires properly.
 

See Wiring connection. (  35)

3  Install the unit to your car.
 

See Installing the unit (in-dash mounting). (  34)

JS_JVC_KD_R988BTS_K_EN_5.indd   33

9/1/2016   11:06:23 AM