IDEMIA Identity & Security France MPHAC001A Manual Do Utilizador
Section 3 : Installation Procedure
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
28
June 2015
If not present, drill in the wall a hole with a diameter adapted to the width of the
terminal and the cable to be hosted in (see Figure 7: Drilling template. This template
at scale 1:1 can be found in the Quick Installation Guide).
terminal and the cable to be hosted in (see Figure 7: Drilling template. This template
at scale 1:1 can be found in the Quick Installation Guide).
Confirm the presence inside the hole of all the cables needed for the electrical
installation (see Electrical Interface)
installation (see Electrical Interface)
Drill in the wall 2 holes with a diameter adapted to screws and fit them with the raw
plugs (see Figure 7: Drilling template).
plugs (see Figure 7: Drilling template).
Fixing
Be sure that a sufficient space is reserved in the wall for the passage of
cables, in particular for Ethernet cable and plug, and also for the Wi-Fi
dongle (if applicable).
cables, in particular for Ethernet cable and plug, and also for the Wi-Fi
dongle (if applicable).
Figure 8: Wall plate fixing
Place the wall plate against the wall, opposite the four holes pierced in the wall (see
Figure 8: Wall plate fixing).
Figure 8: Wall plate fixing).
Cabling
Cable for wiring shall be AWG 20 to 24, length shall be adapted to the size of the hole
in the wall, to terminal connections, and to the distant between the electric source
and the terminal itself.
in the wall, to terminal connections, and to the distant between the electric source
and the terminal itself.
Closing
Power has to be set up just after closing it. If product has to be stored for a long time
(more than 48 hours), don’t forget to restore its configuration before use.
(more than 48 hours), don’t forget to restore its configuration before use.
Finally, lock the product with the screw at the bottom of the terminal.
!