Walter Kidde Portable Equipment Inc. 9000162 Manual Do Utilizador
Figure 5
CAUTION! Alarm will not engage to bracket unless all three batteries are installed. Removal of any or all batteries
will render the alarm inoperative!
MOUNTING INSTRUCTIONS
CAUTION: THIS UNIT IS SEALED. THE COVER IS NOT REMOVABLE!
1.
Complete the steps in section 3, WIRELESS INTERCONNECT SETUP.
2.
Remove mounting plate from the back of the unit by holding the rim of the mounting plate and twisting counterclockwise (left).
3.
Hold the mounting plate against the selected installation location (wall or ceiling) and mark the center of the holes with a pencil.
To ensure aesthetic alignment of the alarm with the hallway, or wall, the “A” line on the mounting plate must be parallel with the
hallway when ceiling mounting, or horizontal when wall mounting (see Figure 6).
To ensure aesthetic alignment of the alarm with the hallway, or wall, the “A” line on the mounting plate must be parallel with the
hallway when ceiling mounting, or horizontal when wall mounting (see Figure 6).
4.
Drill a hole through the pencil marks and use the enclosed screws and anchors to secure the mounting plate (use 3/16”drill bit for
anchor holes).
anchor holes).
5.
Install the alarm on the mounting bracket and rotate the alarm clockwise until the alarm ratchets into place (this ratcheting
function allows for aesthetic alignment). NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
function allows for aesthetic alignment). NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
6.
The green LED should blink once every 10 seconds.
7.
Test the unit to ensure proper operation by pressing the Test Button, all interconnected alarms should respond.
CAUTION: Due to the loudness of the alarm, always stand an arms length away from the unit when testing.
Tamper Resist Features
This alarm has a tamper resist feature, which helps prevent someone from removing the unit from the mounting bracket. Activate the
smoke alarm tamper resist feature by breaking off the four posts in the square holes in the mounting bracket (see Figure 7A). When
the posts are broken off, the tamper resist tab on the base is allowed to engage the mounting bracket. Rotate the alarm onto the
mounting bracket until you hear the tamper resist tab snap into place, locking the alarm on the mounting bracket. Using the tamper
resist feature will help deter children and others from removing the alarm from the bracket. NOTE: To remove the alarm when the
tamper resist tab is engaged, press down on the tamper resist tab, and rotate the alarm off the bracket (see Figure 7B)
Tamper Resist Features
This alarm has a tamper resist feature, which helps prevent someone from removing the unit from the mounting bracket. Activate the
smoke alarm tamper resist feature by breaking off the four posts in the square holes in the mounting bracket (see Figure 7A). When
the posts are broken off, the tamper resist tab on the base is allowed to engage the mounting bracket. Rotate the alarm onto the
mounting bracket until you hear the tamper resist tab snap into place, locking the alarm on the mounting bracket. Using the tamper
resist feature will help deter children and others from removing the alarm from the bracket. NOTE: To remove the alarm when the
tamper resist tab is engaged, press down on the tamper resist tab, and rotate the alarm off the bracket (see Figure 7B)
Figure 6