HARRIS CORPORATION TR-0103-E Manual Do Utilizador
14222-5000-3000
31
6 POWER-UP
1. Transmitter and receiver antenna ports should be connected to 50 ohm load resistors of sufficient
power rating until the system is programmed to the proper operating frequencies and ready to be
deployed.
deployed.
2. Verify the post installation inspection in Section 5 is complete.
3. Apply power to the equipment from the AC mains breaker or switch.
4. Set all power switches on the PSU modules to the On position.
5. Verify all modules power up properly with no alarms (refer to Table 6-1).
Table 6-1: Power and Alarm Indicator Checklist
NOTE
If any LED indicators indicate a failure, power down the cabinet, reseat the modules,
and re-power the cabinet. If the issue persists, contact you dealer.
and re-power the cabinet. If the issue persists, contact you dealer.