Bruno Independent Living Aids Inc PCB4950 Manual Do Utilizador

[ ]

Make the connections to the Charger Wiring Harness.

[ ]

Route the Charger Wiring Harness along the back side
of the Rail and secure it to the Rail Mounting Clamps
with wire ties. Be sure that this wiring is mounted
securely so that it is not vulnerable to physical damage.

[ ]

Coil any excess harness wire and attach to a Rail Clamp
(under the rail).

NOTE: THE CHARGER SHOULD BE PLUGGED INTO A
HOUSEHOLD OUTLET ALL OF THE TIME. THE ELEVATOR IS
DESIGNED SO THAT THE BATTERIES WILL BE CHARGED
WHEN THE CARRIAGE IS AT ONE OR THE OTHER END OF
THE RAIL. IT IS IMPERATIVE THAT THE CARRIAGE BE
"PARKED" AT THE END OF THE RAIL WHEN IT IS NOT IN USE
TO MAINTAIN FULL BATTERY CHARGE.

IN AN INSTALLATION WHERE THE CARRIAGE CAN NOT BE
PARKED AT THE END OF THE RAIL (STAIRWAYS WITH A
DOOR AT THE TOP, FOR EXAMPLE), THE CARRIAGE
SHOULD BE RUN TO THE OTHER END OF THE RAIL WITH
THE REMOTE CALL/SEND MODULE WHEN NOT IN USE.
THIS WILL ENSURE THAT THE BATTERIES WILL REMAIN
FULLY CHARGED.

FIGURE 17

SUGGESTION:

AFTER ROUTING THE

WIRE HARNESS OUT OF

SIGHT A SMALL PIECE

OF DOUBLE SIDED

FOAM TAPE CAN BE

APPLIED TO THE

HARNESS PLUGS AND

ATTACH UNDER THE

RAIL.

NOTE:

IF CHARGER PLUG AND

WIRE ARE LOCATED IN

A VULNERABLE

LOCATION, A PLUG

LOCK TO PREVENT

ACCIDENTAL

UNPLUGGING IS

RECOMMENDED.

THESE ARE AVAILABLE

AT HARDWARE AND

DEPARTMENT STORES.

RAIL CHARGER LEAD

LEAD TO BATTERY
CHARGER WIRING
HARNESS

ROUTING WIRE HARNESSES

INSTALLATION